![background image](http://html1.mh-extra.com/html/omron/cj1w-nc271-12-2009/cj1w-nc271-12-2009_operation-manual_742348081.webp)
53
External I/O Circuits
Section 3-3
Control Output Circuit
Note
The circuit is equipped with an auto-resetting circuit breaker to protect the out-
put. Even if an overcurrent trips the breaker, the breaker will reset automati-
cally after a certain time elapses with no current.
3-3-6
SMARTSTEP Junior Servo Drive I/O Signals (R7D-ZN
@
-ML2 with
Built-in MECHATROLINK-II Communications)
This section describes the standard I/O signals used with a Position Control
Unit when using a SMARTSTEP Junior Servo Drive with Built-in MECHA-
TROLINK-II Communications.
Refer also to the
SMARTSTEP Junior Servo Drive with MECHATROLINK-II
Communications User’s Manual
(Cat. No. I554).
Terminal Arrangement of Control I/O Connector (CN1)
The default control I/O signal allocations for a SMARTSTEP Junior Servo
Drive with MECHATROLINK-II Communications are set to the standard Servo
Drive settings for using MECHATROLINK. The default pin arrangement of the
control I/O connector (CN1) on the Servo Drive are shown below.
Only the I/O signals that are connected to the Position Control Unit are shown.
Refer to
6-4 Standard Settings for Servo Drives Using MECHATROLINK
for
the standard Servo Drive settings for using MECHATROLINK.
Note
(1) Do not connect unused pins.
23
SO2+
General-purpose
output
These control input signals are not used with the
standard settings.
All modes
24
SO2
−
25
SO3+
26
SO3
−
Shell
FG
Frame ground
Use this terminal to connect the cable's shield and
FG wire.
All modes
Pin No.
Symbol
Name
Function/Interface
Control mode
Servo Drive
To other output circuit
X
Di
+
−
See note.
Di: Diode providing surge-voltage protection (Use a high-speed diode.)
External power
supply
24
±
1 VDC
Voltage: 30 VDC max.
Output current: 50 mA max.
1
EXT1
External
latch signal
1 input
8
---
---
2
DEC
Origin prox-
imity input
9
---
---
3
NOT
Reverse
drive inhibit
input
10 ---
---
4
POT
Forward
drive inhibit
input
11 ---
---
5
+24VIN
+
24 VDC
control
power sup-
ply input
12 ALM
Alarm output
6
STOP
Emergency
stop input
13 BKIR
Brake inter-
lock output
7
0GND
Output
ground
common
14 ---
---
Содержание CJ1W-NC271 - 12-2009
