LEGRAND Raritan PX3TS, Руководство пользователя

Страница: 601 / 911

Chapter 9: Using the Command Line Interface
581
config:# network ipv4 staticRoutes modify <route_ID> dest <dest-2> interface
<ETH>
Variables:
•
<dest-1> is a combination of the IP address and subnet mask of the other
subnet. The format is
IP address/subnet mask .
•
<hop> is the IP address of the next hop router.
•
<ETH> is one of the interfaces: ETH1/ETH2 , WIRELESS and BRIDGE . Type
"bridge" only when your PX3TS is in the bridging mode.
•
<route_ID> is the ID number of the route setting which you want to delete
or modify.
•
<dest-2> is a modified route setting that will replace the original route
setting. Its format is
IP address/subnet mask . You can modify either the IP
address or the subnet mask or both.
Configuring IPv6 Parameters
An IPv6 configuration command begins with network ipv6 .
Setting the IPv6 Configuration Mode
This command determines the IP configuration mode.
config:# network ipv6 interface <ETH> configMethod <mode>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2 , WIRELESS , or BRIDGE .
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Determine the IPv6 configuration mode of the ETH1
interface (wired networking).
eth2 Determine the IPv6 configuration mode of the ETH2
interface (wired networking).
wireless Determine the IPv6 configuration mode of the
WIRELESS interface (that is, wireless networking).