LEGRAND Raritan PX3TS, Руководство пользователя

Страница: 604 / 911

Chapter 9: Using the Command Line Interface
584
Setting the IPv6 Gateway
After selecting the static IP configuration mode, you can use this command to
specify the gateway.
config:# network ipv6 gateway <ip address>
Variables:
•
<ip address> is the IP address of the gateway. This value uses the IPv6
address format.
Setting IPv6 Static Routes
If the IPv6 network mode is set to static IP and your local network contains two
subnets, you can configure static routes to enable or disable communications
between the PX3TS and devices in the other subnet.
These commands are prefixed with network ipv6 staticRoutes .
Depending on whether the other network is directly reachable or not, there are
two methods for adding a static route. For further information, see
Static
Route Examples (on page 324).
Method 1: add a static route when the other network is NOT directly
reachable:
config:# network ipv6 staticRoutes add <dest-1> nextHop <hop>
Method 2: add a static route when the other network is directly
reachable:
config:# network ipv6 staticRoutes add <dest-1> interface <ETH>
Delete an existing static route:
config:# network ipv6 staticRoutes delete <route_ID>
Modify an existing static route:
config:# network ipv6 staticRoutes modify <route_ID> dest <dest-2>
nextHop <hop>
-- OR --