LEGRAND Raritan PX3TS, Руководство пользователя

Страница: 680 / 911

Chapter 9: Using the Command Line Interface
660
Removing an Existing LDAP Server
This command removes an existing LDAP server from the server list.
config:# authentication ldap delete <server_num>
Variables:
•
<server_num> is the sequential number of the specified server in the LDAP
server list.
Radius Settings
All Radius-related commands begin with authentication radius .
If you enable Radius authentication, you must add at least one Radius server.
Later you can modify or delete any existing Radius server as needed.
Adding a Radius Server
You can repeat the following commands to add Radius servers one by one.
Command syntax:
config:# authentication radius add <host> <rds_type> <auth_port> <acct_port> <timeout>
<retries>
Variables:
•
<host> is the IP address or host name of the Radius server.
•
<rds_type> is one of the Radius authentication types: pap, chap,
msChapV2 .
Type Description
chap
CHAP
pap
PAP
msChapV2
MSCHAP v2
•
<auth_port> is the authentication port number.
•
<acct_port> is the accounting port number.
•
<timeout> is the timeout value in seconds. It ranges between 1 to 10
seconds.
•
<retries> is the number of retries. It ranges between 0 to 5.
To enter the shared secret:
1. After executing the above Radius command, the system automatically
prompts you to enter the shared secret.
2. Type the secret and press Enter.
3. Re-type the same secret and press Enter.