Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1035/1568
11.2.2.3
Configuring Service Port Page
You use this panel to specify the parameters needed to communicate with the switch over a network
using the service port.
Configurable Data
Protocol
- Choose IPv4 or IPv6 protocol.
Non-Configurable Data
Interface Status
- Indicates whether the link status is up or down.
IPv4 Selection Criteria
Service Port Configuration Protocol Current
- Choose what the switch should do following
power-up: transmit a Bootp request, transmit a DHCP request, or do nothing (None). The factory
default is None.
You cannot make this choice for both the network configuration protocol and the service port. You
will only be given the choices for Bootp or DHCP here if the network configuration protocol is
configured to None.
IPv6 Selection Critieria
IPv6 Mode
- Enable/Disable IPv6.
Service Port Configuration Protocol
- Enable or Disable DHCPv6 Client protocol on the
management port. The factory default is None.
IPv6 Stateless Address AutoConfig Mode
-Enable or Disable the IPv6 stateless address
autoconfiguration on the management port. The factory default is Disable.
Add/Delete IPv6 Addresses -
To Add or Delete the IPv6 Addresses, select Add or Remove from
the drop-down menu. The fields "New IPv6 Address" and "EUI Flag" are visible when we select the
"Add" from this menu.
Change IPv6 Gateway -
Select the checkbox to configure/change/remove IPv6 Gateway Addresses.
To configure / change the Ipv6 gateway, select the checkbox and enter the desired value in the "IPv6
Gateway" textbox. To remove, select the checkbox, the textbox "IPv6 Gateway" has to be empty and
click submit button.
IPv4 Configurable Data
IP Address
- The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask
- The IP subnet mask for the interface. The factory default value is 0.0.0.0
