Ross Synergy MD, Инструкция по эксплуатации, Страница: 93 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Physical Installation • 3–29
4. Echo Connector
One 6-pin RJ-12 Telco connector is provided for daisy-chaining the remote panel to the
next remote Aux panel in line. Refer to the section “
Remote Aux Panel Cabling ” on
page 4-4 for connection details. Refer to Appendix A for pinouts.
5. AC Adapter
One AC Adapter (90 - 264 VAC) is provided with each remote Aux panel as a source of
+5 VDC. Please note:
• 90 - 264 VAC adapter, p/n
103-012
Refer to the section “ Remote Aux Panel Cabling ” on page 4-4 for connection details.
6. Cable Retainer
Loop the cable from the AC adaptor through the cable retainer on the back on the panel
for better security.
Please note:
• There are no user-settable jumpers in the Aux panels.
• Assignable Aux panels are configured using the control panel menu system. A special
programming mode allows you to assign “rights” for each of the available Aux outputs
to an assignable Aux panel.
• Dedicated Aux panels are also configured using the control panel menu system. A
special programming mode allows you to assign one specific Aux output to each
dedicated panel.
Refer to the section “ Aux Bus Setup ” on page 11-2 for instructions for both assignable and dedicated
Aux panels.
Installation Procedure
Use the following procedure to install remote Aux panels:
1. Install the appropriate panels in the desired locations for your facility.
2. Connect the supplied AC adapter to a suitable source of line voltage.
3. Plug the DC connector into the rear of the remote Aux panel.
4. Repeat steps 2 and 3 for each Aux panel.
This completes the remote Aux panel installation procedure.