Ross Synergy MD, Инструкция по эксплуатации, Страница: 237 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Basic Communications Setup • 9–11
Pbus Protocol Setup
Use the Pbus Protocol Setup procedure to set up communications parameters with a Pbus device that
can control up to 24 peripheral devices from a single remote port on the Synergy Q/MD switcher.
Ensure that the Pbus Protocol option is installed. If not, please contact Ross Video for details. Refer
to the section “ Installed Options ” on page 6-27 for instructions on verifying the status of installed
options.
Use the following procedure to configure a Synergy Q/MD switcher communication port for a
Peripheral Interface II Protocol device:
1. Navigate to the Communications Menu 1-2 as follows:
• Press HOME B MORE B Setup B Installation B Communications .
2. Press Type to display the Type Menu .
Communications — Type Menu
3. Assign a communication port to the Pbus as follows:
• Use the
Com Port
knob to select the remote port on the Synergy Q/MD switcher
that is connected to the Pbus device.
• Use the
Device
knob to select
Pbus
.
4. Press Select Device to display the Select Device Menu .
Communications — Select Device Menu
5. Select the Pbus protocol for the Pbus communications port as follows:
• Use the Com Port knob to select the Synergy Q/MD remote port that the
Peripheral Interface II Protocol is controlling.
• Use the Device knob to select Pbus .