Ross Synergy MD, Инструкция по эксплуатации, Страница: 350 / 388

12–8 • Completing Setup Synergy Q/MD Engineering Manual (v9.1 MD)
Favorite CG Setup
This setup procedure allows you to select a “favorite” CG that you want to assign to the CHAR GEN
button in the MLE Key 2 Group of an upper MLE. The location of the button is shown below:
CHAR GEN (Favorite CG) Button Location
The button allows you to instantly recall and select your most frequently-used character generator,
without having to hunt for it on the
Key Bus — thus saving two steps during production: (1) selecting
the key type, and (2) selecting the key source.
Use the following procedure to program the “favorite” CG button:
1. Press and hold the CHAR GEN button in the Keyer of any MLE.
2. On the selected Key Bus of the MLE, press the button for your most frequently used CG.
3. Release both buttons. The selected CG is now stored in memory, and will be recalled
each time CHAR GEN is pressed — in any MLE.
This completes the procedure for programming the “favorite” CG button.
Please note:
• If you have a key type already set up when you press CHAR GEN , the entire keyer is
cleared. In addition to the favorite CG, the system will automatically select AUTO
SELECT and (if an Auto Key has been properly set up during installation), KEY MEM .
• The “favorite” CG programming function is global. Regardless of where you program
the function, all
CHAR GEN buttons (in all MLEs) will now recall the selected CG.
O
N
MLE 1 K
EY
2
SELF
KEY
MATTE
FILL
KEY
MEM
KEY
PV
CHAR
GEN
CUT
AUTO
TRANS
KEY
INV
MASK
AUTO
SELECT
CHROMA
KEY
PST
PATT
FLY
KEY
BORD
SHDW
OUTL
BORD
OFF