Ross Synergy MD, Инструкция по эксплуатации, Страница: 80 / 388

3–16 • Physical Installation Synergy Q/MD Engineering Manual (v9.1 MD)
Removing or Installing the Frame Door
If you are installing hardware options, or replacing circuit boards or power supplies, you will be
required to remove and re-install the frame door.
QMD/X Frame
The door on the QMD-X and QMD frames swings open, allowing for quick access to the boards and
cards in the frame. The door can also be completely removed for greater access into the frame.
Use the following procedure to open the door of the QMD-X or QMD frame:
1. Gently pull the door latch out and rotate it to release the door. The QMD-X door has two
latches.
Frame Door Overview (QMD Shown)
2. Swing the door open, as shown.
This completes the procedure for opening the door of the QMD-X or QMD frame.
Caution
The frame door must be installed on the frame for proper cooling.
Leaving the frame door off may cause the frame to overheat, resulting
in unexpected behavior or damage to equipment.
Operating
Tip
To remove the door from the frame completely, open the door to its full
extent. The door will be perpendicular to the front of the frame. Lift the
door directly up to unhook it from the hinge pins and remove the door
from the frame.
Top of Frame
Door Latch
Frame Door
Door Hinge
Door Swing
Direction