Ross Synergy MD, Инструкция по эксплуатации, Страница: 239 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Basic Communications Setup • 9–13
10. Press
Extra Options
to display the Extra Options Menu .
Communications — Extra Options Menu
11. Select the type of querying command for the Pbus device as follows:
• Use the Com Port knob to select the Pbus device you want to set the querying
command type for.
• Use the Option knob to select Query Cmd .
• Use the Value knob to select the type of Query Command you want. You can select
between the following:
~
Strict — Select this option to be able to control only devices connected to your
Pbus device that respond to the Query Command
~ Relaxed — Select this option to be able to control all devices connected to
your Pbus device whether they respond to the Query Command or not.
~ Silent — Select this option to not send status information from the switcher to
your Pbus device.
This completes the procedures for setup of the Peripheral Interface II Protocol option.
Refer to the section, “ Switcher Personality ”, in the chapter, “ Switcher Basics ”, of the Synergy
Q/MD/X Operator’s Manual for operating settings.
Refer to the section “ Pbus ” on page 10-35 for procedures on creating custom controls using the Pbus
Protocol option.
Note
When you have completed setting up a device, or attempt to leave the
Communications Menu , you will be prompted to Confirm or
Cancel your changes to the installation settings of the switcher. If you
want to keep the changes you have made, press Confirm , and the new
setting will be stored.