Ross Synergy MD, Инструкция по эксплуатации, Страница: 261 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–15
Use the following procedure to program a relative custom control button with basic functions:
1. Set up your MLE re-entry configuration to record the relative custom control at the
Re-entry level you want.
2. Navigate to the Custom Controls Menu 1-2 as follows:
• Press
HOME B Custom Controls
.
Custom Controls Menu 1-2
3. Select the Custom Control bank and button that you want to record to as follows:
• Use the Bank knob to select the custom control bank that you want to record the
custom control on.
• Use the
Button
knob to select the custom control button that you wish to program.
You can also press the button directly on the panel.
Important If you record a relative custom control across multiple re-entered
MLEs, at least the same number of MLEs must be re-entered in order
to recall the entire custom control. For example, if a two MLE relative
custom control is recalled on one MLE, the actions to be recalled on
the second MLE will be ignored.
Note You must record a relative custom control on an MLE that is re-entered
onto the PGM/PST MLE for it to run properly.
Note Buttons with an at ( @ ) next to them in the list are already programmed
with a relative custom control, however, they can be overwritten or
edited. Refer to the section “
Editing Custom Control Macros ” on
page 10-42 for more information.
MLE 1
MLE 2
Configuration 3
MLE 3
On-Air
Configuration 4
MLE 3
On-Air