Ross Synergy MD, Инструкция по эксплуатации, Страница: 110 / 388

4–10 • Preliminary Cabling and Video Installation Synergy Q/MD Engineering Manual (v9.1 MD)
Resetting the Switcher
If required, the Synergy Q/MD can be reset manually from the control panel. There are three types of
resets:
• A Full Restart affects hardware and software simultaneously
• A Software Reset affects software only
• A Global-Store Restart affects the Global-Store and video processor only.
Full Restart
This function performs both a hardware and a software reset simultaneously. Switcher memory
registers, personality registers, installation registers, and custom control registers are not affected by
the reset, but all other switcher parameters (for example, the current state of the panel) are reset.
BLACK
will be selected on all buses.
Use the following procedure to perform a full restart of the switcher:
1. Navigate to the System Shutdown Menu as follows:
• Press
HOME B MORE B System Shutdown
.
System Shutdown Menu
2. Press
Restart
.
The system will prompt you to confirm the restart. Once confirmed, the frame will
power down and boot up again.
Software Reset
The software reset function can be performed from either the Global Memory System Group or any
individual MLE Memory System Group on the control panel. Both methods are described below.
Resetting the Switcher from the Global Memory Group
From the Global Memory System Group you can reset either all the MLEs on the system, or each
MLE individually. Use the figure below for reference:
Important Do not turn the switcher frame power off until you have completed the
proper shutdown procedure or you may damage the hard disk. Refer to
the section “
Shutting Down the Switcher ” on page 4-14 for this
procedure.