Ross Synergy MD, Инструкция по эксплуатации, Страница: 323 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–21
The custom control button on the switcher panel that corresponds to the active line
for the bottom
Cust Ctrl
knob lights up during the selection process. The lighted
button changes as the knob is turned.
If the current custom control setting is for a control button in a bank, and that bank
has a button assigned to activate it, then both the bank button and the control button
will light.
It is also possible to specify the custom control setting by pressing the actual custom
control button.
• When
Mem Recall
is selected, the label for the bottom knob changes to
Memory
and the values change to a list of memories (
Memory0
to
Memory99
) that can be
recalled by triggering a GPI input.
GPI Input Setup Menu — “Memory” selected
2. Using the information from the Event Type and Event Area columns in your
Standard GPI Input Worksheet , select the first GPI input that you want to program.
Assign a “function” and select an “area” of the switcher, or “Cust Ctrl”, or “Mem
Recall” to trigger.
Note that if the label USED appears to the right of the GPI input port number, it
indicates that the selected port is already in use by the Aux Bus, as assigned on the Aux
Bus GPI Tally Assign Menu . Refer to the section “ Assigning Aux Bus Tallies ” on
page 11-5 for instructions.
For reference, the figure below illustrates the USED label on the GPI Input Setup
Menu .
GPI Input Setup Menu — GPI Port in Use