Ross Synergy MD, Инструкция по эксплуатации, Страница: 116 / 388

4–16 • Preliminary Cabling and Video Installation Synergy Q/MD Engineering Manual (v9.1 MD)
Preliminary Functional Check
At this point, the basic connections have been completed. With the switcher powered up, a
preliminary functional check can be performed to ensure that the switcher is passing video. A variety
of tests can be performed, including:
• Dissolves between BLACK and COLOR BKGD
• Wipes between BLACK and COLOR BKGD
• Fade to black
All Ross Video products undergo thorough quality control and testing before shipment. The following
preliminary check ensures that no damage has occurred during transit, and that all boards are correctly
installed. Once the preliminary check is complete, the remaining installation procedures can be
performed.
With your video monitor properly connected, perform the following procedure for a preliminary
check:
1. Perform a full software reset, as outlined in the section “ Software Reset ” on page 4-10.
This sets the panel to a full reset state.
2. Check the status of the control panel. In a reset (or “default”) condition, the following
buttons and indicators will be lit:
• The first input (typically BLACK ) is selected on all MLE buses.
• The first input (typically BLACK ) is selected on the Aux Bus .
• The red LED at the right edge of the PGM (Program) Bus is lit. This indicates that
the PGM Bus is on air.
• In the Preview Bus group, MLE# PV is lit. This will be the preview for your
BKGD/PST bus
• In the Aux Bus Assign group, BANK 1, AUX 1 is lit.
• In each MLE Transition group, the BKGD and DISS buttons are lit. A background
dissolve is the default transition.
• In the Program/Preset Transition group, the BKGD and DISS buttons are lit.
• ( Synergy 3 control panel only )In each MLE Memory System group, the RECALL
button is lit and the display shows the following information (for the specific MLE):
~
REG:00 — Memory register 00 is preset
~ Memory0 — Memory register 00 was last recalled
~ MLE:015 — MLE transition rate is 15 frames
~ Key:008 — Key transition rate is 8 frames
• In the Global Memory System group, under the “ Recall ” heading, the following
buttons are lit:
~ Synergy 1 Q/MD : RECALL
~ Synergy 2 Q/MD : MLE 2
~ Synergy 2.5 Q/MD : MLE 3