Ross Synergy MD, Инструкция по эксплуатации, Страница: 313 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–11
Remote Aux Panel GPI Connection
In this section, you will wire each remote Aux panel GPI port to the designated joystick switch on a
selected camera CCU. If you wish to connect GPIs on
more than one panel to different CCU joysticks,
each connector must be wired at this time. The GPI connector is located on the rear of each remote
Aux panel.
• Using the “ Remote Aux Panel GPI Input Worksheet ” as a guide, label the rear of each
panel with its assigned group and offset . A sample label is shown below.
• Using the “ Remote Aux Panel GPI Pinout Table ” provided in Appendix A, together
with the data from your “ Remote Aux Panel GPI Input Worksheet ” wire the
appropriate GPI ports to each designated Camera CCU. Refer to the Installation
Manual for your camera for pinout information on the Joystick contact closure on the
camera. Momentary action, normally-open switches are recommended.
• The GPI Port on the Remote Aux Panel is a 9-pin D-Type female connector.
• GPI In 1-8: Active low, short-to-ground to activate
• Run all GPI cables in accordance with good engineering practice, and ensure that the
cable will not be subjected to physical abuse.
55 Group 7, Offset 6, GPI 7
56 Group 7, Offset 6, GPI 8
57 Group 8, Offset 7, GPI 1
58 Group 8, Offset 7, GPI 2
59 Group 8, Offset 7, GPI 3
60 Group 8, Offset 7, GPI 4
61 Group 8, Offset 7, GPI 5
62 Group 8, Offset 7, GPI 6
63 Group 8, Offset 7, GPI 7
64 Group 8, Offset 7, GPI 8
Note Refer to Appendix A, “ Specifications ” for Aux panel GPI connector
specifications.
Remote Aux Panel GPI Input Worksheet
Remote GPI Group / Offset /
Physical GPI
Assigned
Aux Bus
Assigned
BNC
Type/Edge Physical
Connection
J5
MAIN
J1
ECHO
J4
POWER
J2
GPI
+5 V REG
1 A
GROUP 1 / OFFSET 0