Ross Synergy MD, Инструкция по эксплуатации, Страница: 124 / 388

4–24 • Preliminary Cabling and Video Installation Synergy Q/MD Engineering Manual (v9.1 MD)
above-mentioned outputs are defaulted to
Program
out. Re-mapping of inputs will be performed in
Chapter 7, “ BNC Configuration and Check ”. Configuration of outputs will be performed in Chapter
8, “ Output Configuration ”. During these procedures, you can map any input to any button on a bus
row, and configure the outputs to be program, preview, clean feed, or Aux Bus outputs.
On the unshifted row, default mapping is as follows:
• BLACK is mapped to button 1.
• GLOBAL-STORE 1 is mapped to the fourth-to-the-last button.
• GLOBAL-STORE 2 is mapped to the third-to-the-last button.
• GLOBAL-STORE 3 is mapped to the second-to-the-last button.
• SHIFT is mapped to the last button in a bus row.
On the shifted row, default mapping is as follows:
• COLOR BKGD 1 is mapped to the first shifted button.
• COLOR BKGD 2 is mapped to the second shifted button.
You can now verify input video signals as they are connected. The following check assumes a default
switcher condition.
• Synergy 1 Control Panel
~ To view the first 11 inputs (inputs
C01
through
C11
), press button
2
through
12
,
respectively. (Buttons
1
,
13
,
14
,
15
, and
16
are already mapped as indicated
above).
~ To view the next 13 inputs (inputs
C12
through
D08
), press
SHIFT +
buttons
3
through
15
, respectively. (Shifted buttons
1
and
2
are already mapped as indicated
above, and button
16
is mapped to SHIFT ).
~ The remaining 8 inputs (inputs
D08
through
D16
) cannot be verified unless
re-mapped.
• Synergy 2 Control Panel:
~ To view the first 12 inputs (inputs
C01
through
C12
), press buttons
2
through
13
,
respectively. (Buttons
1
,
14
,
15
,
16
, and
17
are already mapped as indicated
above).
~ To view the next 14 inputs (inputs
C13
through
D10
), press
SHIFT +
buttons
3
through
16
, respectively. (Buttons
1
and
2
are already mapped as indicated above,
and button
17
is mapped to SHIFT ).
~ The remaining 6 inputs (inputs
D11
through
D16
) cannot be verified unless
re-mapped.
• Synergy 3 Control Panel:
~ To view the first 25 inputs (inputs
C01
through
D09
), press buttons
2
through
26
,
respectively. (Buttons
1
,
27
,
28
,
29
, and
30
are already mapped as indicated
above).
~ To view the next 7 inputs (inputs
D10
through
D16
), press
SHIFT +
buttons
3
through
9
, respectively. (Buttons
1
and
2
are already mapped as indicated above,
and button
30
is mapped to SHIFT ).