Ross Synergy MD, Инструкция по эксплуатации, Страница: 117 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Preliminary Cabling and Video Installation • 4–17
• The default display in the Global Memory System of the Synergy 1.5, 2 and 2.5
Q/MD switchers indicates the following information (for the DSK and the
Program/Preset MLE):
~
REG:00
— Memory register 00 is preset
~
Memory0
— Memory register 00 was last recalled
~
M:015
— MLE transition rate is 15 frames
~
D:008
— DSK transition rate is 8 frames
~
F:20
— DSK fade-to-black transition rate is 20 frames
• In the Global Memory System group of the Synergy 1 Q/MD , the display shows
the following information:
~
REG:00
— Memory register 00 is preset
~
Memory0
— Memory register 00 was last recalled
~
M:015
— The MLE transition rate is 15 frames
~
K:008
— The key transition rate is 8 frames
~
F:20
— The fade-to-black transition rate is 20 frames
• In each MLE Key 1 and Key 2 group, the
AUTO SELECT
button is lit.
• ( Not applicable on the Synergy 1 control panel ) In each switcher Downstream
Keyer group, source 1 is selected.
• ( Not applicable on the Synergy 1 control panel ) At the far right edge of each MLE
Key Bus , the green
KEY 1
LED is lit. This indicates that the Key 1 Bus is active.
• In the Positioner group, the
MLE 1
and
PATT
buttons are lit. Note that the
MLE 1
button does not exist on the Synergy 1 control panel.
• In each switcher Mattes group, there is no default selection. Therefore the last
buttons selected will be lit.
• In the Pattern Control group, the
MLE 1
,
PP1
,
NORM
, and
Vertical Wipe
(upper left wipe) buttons are lit. Note that the
MLE 1
button does not exist on the
Synergy 1 control panel.
• ( Synergy 3 control panel only ) In the DVE Send group, the MLE 1 button is lit.
3. Select sources for the transition:
• Ensure that
BLACK
is selected on the PGM Bus .
• Select
COLOR BKGD 1
on the PST (Preset) Bus .
~ Color Background 1 is factory preset to red.
~ Color Background 2 is factory preset to blue.
4. Ensure that DISS is selected in the PGM/PST MLE Transition group.
5. While watching the monitor, move the fader from one limit to the other, and verify that
the video dissolves from black to color.
Note When lit, the Up/Down arrows adjacent to the fader indicate which
direction to move the fader to complete the transition.