Ross Synergy MD, Инструкция по эксплуатации, Страница: 285 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–39
• Press
Next Letter
to accept the currently selected letter and begin selection of the
next letter.
• Press
Space
if you want to enter a space in the name.
5. Assign a Preset Name to the custom control as follows:
• Press
Preset Names
to display the Preset Names Menu .
Preset Names Menu
• Use the Name knob to select a preset name (a prefix) from the list of typical custom
control names.
• Press
Select
to accept the preset name, or
Cancel
to return to the previous menu.
6. Press Accept New Name to save the new name.
• Press
Yes
to abandon changes and move to the new custom control number. The
name reverts to its previous name as stored in memory.
• Press
No
to retain changes without moving to the new custom control number.
This completes the procedure for naming your custom controls.
Note If you make a mistake, you can use the Prev Letter button to go back
and adjust a letter.
Note If you start editing the name immediately, and then decide at some
point to choose a
preset name instead, all characters in the custom
name will be replaced by the preset name.
Operating
Tip
A standard PS/2 keyboard can be used to perform the same actions as
pressing or rotating the
System Control buttons and knobs.
Operating
Tip
You can edit a preset name on the Custom Name Menu just as you
would a New Name you entered. Refer to step 4 above.
Note If you exit the installation menus without first pressing Accept New
Name , the following screen is displayed.
The entry “ --- ” has changed to “ --- ”, abandon the changes?