Ross Synergy MD, Инструкция по эксплуатации, Страница: 307 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–5
~
Follow
— Select this option to place the specific Aux Bus in follow (or “view
only”) mode. You can select the bus in the Aux Bus Assign Group and follow
what crosspoints are being selected (remotely), but you cannot change
crosspoints. In this configuration, the bus is controlled from another location.
This completes the procedure for setting up a local Aux Panel.
Assigning Aux Bus Tallies
When an Aux Bus is used to route video to an external device (such as a VTR), this procedure sets up
the method for tallying that bus. By selecting certain parameters, you can tally the bus (lighting the
red “
ON ” LED on the Aux Panel) whenever the device is used on-air, or as part of the composite on
air image.
Remote Aux Panel Tally
Use the following procedure to select the Aux Bus tally method:
1. Navigate to the Aux Bus Menu as follows:
• Press HOME B MORE B Setup B Installation B Aux Bus .
2. Press Ext Device Assign to display the External Device Assignment Menu .
Aux Bus — External Device Assignment Menu
3. Assign an Input BNC and tally method to an Aux Bus as follows:
• Use the Aux Bus knob to select the Aux Bus that connected to the input of the
external device.
• Use the BNC knob to select the Input BNC that is connected to the output of the
external device.
• Use the Tally when knob to select the how the Aux Bus is tallied. You can select
between the following:
~
No Tally — Select this option to prevent the Aux Bus from being tallied,
regardless of what is selected on air.
Note
For example, by telling the switcher that
Bnk1
,
Aux1
feeds VTR 1,
the switcher will tally
Bnk1
,
Aux1
whenever VTR 1 is taken on air.
BLCK
MLE
1
MLE
2
MLE
3
CLEAN
FEED
PGM
ASSIGN
+4
ASSIGN
+8
ASSIGN
1
ASSIGN
2
ASSIGN
3
ASSIGN
4
SHIFT PV
Tally
(Aux Bus "Active")