Ross Synergy MD, Инструкция по эксплуатации, Страница: 315 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–13
6. Test your GPIs locally for valid contact closures by pressing each joystick button on the
CCUs that are connected to this panel.
As you press the CCU joystick buttons, the LEDs in the second group of eight
crosspoints on the panel will indicate when each GPI has been shorted to ground, as
shown below.
Remote Aux Panel Button GPI Contact Closure Status Buttons
When each GPI is shorted to ground, the corresponding
GPI Icon
on the Remote Panel
Setup Menu will light. Refer to the section “ Monitoring CCU Joystick Selections ” on
page 11-15 for more information on GPI icons.
7. Press
Accept
on the Remote Panel Setup Menu to store the new settings on the
Remote Aux Panel and exit programming mode.
Refer to Appendix A, “ Specifications ” for a comprehensive table that lists all normal, GPI, and
special diagnostic Aux panel programming modes.
Setting Up CCU Joystick Aux Control
Once the remote GPIs have been wired, and the remote panels have been programmed with the proper
offsets, you can now assign each remote GPI to an Aux Bus and an Input BNC on the switcher, and
select the desired trigger type for it.
Use the following procedure to configure your CCU joystick Aux control as follows:
1. Navigate to the Aux Bus Menu as follows:
• Press HOME B MORE B Setup B Installation B Aux Bus .
2. Press Remote Panels to display the Remote Panels Menu .
3. Press Remote GPI Assignment to display the Remote GPIs/CCU Joystick Control
Menu .
Remote Panels — Remote GPIs/CCU Joystick Control Menu
Important GPI status buttons are numbered from left to right, starting at GPI 8
and counting down to GPI 1 . These correspond to the 8 available ports
on each panel, and also correspond to the arrangement of GPI icons on
the
Remote Panel Setup Menu .
BLCK
MLE
1
MLE
2
MLE
3
CLEAN
FEED
PGM
ASSIGN
+4
ASSIGN
+8
ASSIGN
1
ASSIGN
2
ASSIGN
3
ASSIGN
4
SHIFT PV
GPI 8
GPI 7
GPI 6
GPI 5
GPI 4
GPI 3
GPI 2
GPI 1