Ross Synergy MD, Инструкция по эксплуатации, Страница: 234 / 388

9–8 • Basic Communications Setup Synergy Q/MD Engineering Manual (v9.1 MD)
to the section “ Programming the BSS4 for Peripheral Devices ” on page 9-8 for more
information.
BSS4 Remote Port Expander
The Slave Ports A , B , C and D on the BSS4 correspond to the Remote #A , Remote #B , Remote
#C , and Remote #D ports on the Communications Setup Menu of the Synergy Q/MD switcher.
The # will be the number of the Remote Port that the BSS4 is installed on. For example, if the BSS4 is
connected to Remote Port 3 , the corresponding expanded BSS4 ports would appear as Remote 3A ,
Remote 3B , Remote 3C and Remote 3D . You connect peripheral devices to these ports in the same
manner you would any of the other Remote Ports on the Q/MD control panel.
Programming the BSS4 for Peripheral Devices
If you set up a device that uses a baud rate or parity that is different than what the remote port on the
BSS4 was set to before, you will have to program the BSS4.
Use the following procedure to program the BSS4:
1. Install and set up communications for your device as you would for a device connected
to a standard remote port.
2. After you confirm the set up of the device from the Communications Menu , the
Program BSS4 Screen is displayed.
BSS4 — Program BSS4 Screen
3. Move the SET UP SWITCH on the BSS4 to
PROG
.
BSS4 Remote Port Expander — Set Up Switch
Slave Port B
Master Port
Power
Slave Port A
Slave Port C
Slave Port D
Model RS422BSS4
RS-422 Four Port Buffered
Smart Switch
SET UP SWITCH
5V --- 100mA PROG. NORM.