Ross Synergy MD, Инструкция по эксплуатации, Страница: 265 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–19
• Use the
Function
knob to select the function that you want to assign to the custom
control. Use the table “ Time Clock Custom Control Functions ” on page 10–19 to
determine which function you want to insert.
7. Press
Insert
to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
8. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
9. Press
UP ONE
to display the Recording Menu .
Custom Controls — Recording Menu
10. Press Finish Recording , or the flashing custom control button, to finish recording to
the selected custom control. The custom control button will stop flashing.
This completes the procedure for programming one or more custom control buttons with special Time
Clock functions.
To play back your macro, press the custom control button on the control panel that you recorded the
custom control macro to.
Note The middle Reset Time knob only applies to the insert Reset
command. No value will be displayed for other commands.
Time Clock Custom Control Functions
Time Clock Functions Description
Count Up Starts the Preview Overlay clock counting up from zero.
Count Down Starts the Preview Overlay clock counting down from the preset time to zero.
Count Down/Up Starts the Preview Overlay clock counting down from the preset time to zero, when
it will then start counting up from zero until you press
Reset
or
Stop
.
Stop Stops the Preview Overlay clock.
Reset Resets the Preview Overlay clock to the preset time.
Operating
Tip
Time Clock functions can be strung together, allowing one custom
control button to perform
multiple functions when it is pressed. For
example, you can have the Reset function following by the Count
Down function, allowing a single custom control macro to reset the
Time Clock and start it counting down.