Ross Synergy MD, Инструкция по эксплуатации, Страница: 271 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–25
4. Press
Insert Special
to display the Insert Special Menu 1-2 .
5. Press
Special
to display the Special Menu .
Insert Special — Special Menu
6. Assign which menu is displayed from the selected custom control macro as follows:
• Use the
Selection
knob to select
Go To Menu
.
• Use the
Type
knob to select
3D
.
• Use the
Menu
knob to select the menu you want to display when the custom control
is run. You can select between the following:
~ Position/Crop — Select this option to display the S&T MD Position/Crop
Menu 1-2 for the active Fly Key when the custom control is run.
~ Border — Select this option to display the S&T MD Border Menu for the
active Fly Key when the custom control is run.
~ Sequence — Select this option to display the S&T Sequence Menu 1-2 for
the active Fly Key when the custom control is run.
~ Preprocessor — Select this option to display the S&T MD Preprocessor
Menu for the active Fly Key when the custom control is run.
~ WARP — Select this option to display the S&T WARP Menu for the active
Fly Key when the custom control is run.
~ Ch Management — Select this option to display the Channel Management
Menu for the active Fly Key when the custom control is run.
7. Press Insert to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
8. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
Note When you run a Go To Menu custom control, the menu that is
displayed will be determined by the current active MLE and Keyer . If
Key 2 is active on MLE 2 , the menu will be displayed for Key 2 on
MLE 2 .