Ross Synergy MD, Инструкция по эксплуатации, Страница: 306 / 388

11–4 • Additional Installation Setups Synergy Q/MD Engineering Manual (v9.1 MD)
Change Name Without Saving Screen
• Press
Yes
to proceed without saving the changes you made to the name.
• Press
No
to return to the previous menu and accept the new name.
This completes the procedure for modifying the name of an Aux Bus.
Setting Up Local Aux Panels
Use the following procedure to set up your local Aux panel:
1. Navigate to the Aux Bus Setup Menu as follows:
• Press HOME B MORE B Setup B Installation B Aux Bus .
2. Press Local Panel to display the Local Panel Menu .
Aux Bus — Local Panel Menu
This menu allows you to set specific switching parameters (or “rights”) for each of the
Aux Buses that are accessible from the control panel (in the
Aux Bus Assign Group ).
Each bus can be set up individually.
3. Configure a local aux bus as follows:
• Use the Aux Bus knob to select the Aux Bus that you want to configure.
• Use the Mode knob to select the mode for the selected local bus. You can select
between the following:
~
OFF — Select this option to turn the specific Aux Bus Off, effectively
disabling access to the bus from the control panel. When the button in the Aux
Bus Assign Group is pressed, it lights momentarily , but it will not “take.” The
bus can, however, be controlled by a Remote Aux panel.
~ Regular — Select this option to place the specific Aux Bus in normal
operating mode. The bus can be selected and sources can be changed from the
control panel. This mode also allows both local and remote panels to control
the Aux Bus.