Ross Synergy MD, Инструкция по эксплуатации, Страница: 231 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Basic Communications Setup • 9–5
5. Assign the BSS4 to the Expander communications port as follows:
• Use the
Com Port
knob to select the communications port you want to assign the
specific BSS4 to.
• Use the
Device
knob to select
BSS4
.
6. Press
Com Settings
to display the Communications Settings Menu .
Communications — Communications Settings Menu
7. Set the communications protocol for the BSS4 as follows:
• Use the
Com Port
knob to select the BSS4 you want to set the communications
settings for.
• Use the
Baud
knob to select
115200
as the baud rate for the BSS4.
• The
Parity
knob is fixed at
NONE
.
8. Press
Com Type
to display the Communications Type Menu .
Communications — Communications Type Menu
9. Select the type of serial communication that will be used to communicate with the BSS4
as follows:
• Use the
Com Port
knob to select the BSS4 you want to set the communications
type for.
• Use the
Type
knob to select
RS-422
as the type of serial communication for the
selected port.
10. Press
HOME
to display the Confirm Changes Screen .
11. Press
Confirm
to accept the changes you have made to communications set up of the
switcher.
Note The BSS4 only supports RS-422 communication. Any device using
RS-232 communication requires an RS-422 to RS-232 converter.
Refer to the documentation for your device to ensure you are using the
correct type of serial communication.