Ross Synergy MD, Инструкция по эксплуатации, Страница: 282 / 388

10–36 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
Custom Controls Menu 1-2
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the Button knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) or an (@) in the
list have already been programmed.
3. Press
Start Recording
to display the Recording Menu .
4. Press
Insert Special
to display the Insert Special Menu 1-2 .
5. Press
PBUS
to display the Insert PIP-II Menu .
Insert Special — Insert PIP-II Menu
6. Assign a command to a Pbus device for the custom control as follows:
• Use the Selection knob to select the Pbus device you want to assign a command
to. You can select between the following:
~ ALL — Select this option to have the Pbus command sent to all Pbus devices
connected on the selected remote port.
~ DevXX — Select this option to have the Pbus command sent to a specific Pbus
device ( Dev 0 to Dev23 ) attached to the selected remote port.
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.
Note
The Ports are identified by the remote port on the Synergy control
panel that the Pbus device is connected to. For example, if a Pbus
device is connected to
Remote Port 1 on the control panel, the ports
for the Pbus device will be labelled as Port R1 DevXX .