Ross Synergy MD, Инструкция по эксплуатации, Страница: 189 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) BNC Configuration and Check • 7–19
•
MLE-Store 4
— Select this option to assign MLE-Store Channel 4 to the selected
crosspoint button.
•
MLE Cln Fd 1
— Select this option to assign the Clean Feed output from MLE 1
to the selected crosspoint button.
•
MLE Cln Fd 2
— Select this option to assign the Clean Feed output from MLE 2
to the selected crosspoint button.
•
MLE Cln Fd 3
— Select this option to assign the Clean Feed output from MLE 3
to the selected crosspoint button.
•
MLE Cln Fd 4
— Select this option to assign the Clean Feed output from MLE 4
to the selected crosspoint button.
•
MLE Preview 1
— Select this option to assign the Preview output from MLE 1 to
the selected crosspoint button.
•
MLE Preview 2
— Select this option to assign the Preview output from MLE 2 to
the selected crosspoint button.
•
MLE Preview 3
— Select this option to assign the Preview output from MLE 3 to
the selected crosspoint button.
•
MLE Preview 4
— Select this option to assign the Preview output from MLE 4 to
the selected crosspoint button.
•
PRV w/ OVL
— Select this option to assign the main Preview output with Overlay
to the selected crosspoint button.
•
AuxKeyCut
— Select this option to assign an AuxKey Cut to the selected
crosspoint button. The AuxKeyCut allows you to perform a cut of the AuxKey
keyer on the selected Aux Bus.
•
AuxKeyTrans
— Select this option to assign an AuxKey Transition to the selected
crosspoint button. The AuxKeyTrans allows you to perform a transition of the
AuxKey keyer on the selected Aux Bus.
• AuxBkgdCut — Select this option to assign an AuxKey Background Cut to the
selected crosspoint button. The AuxBkgdCut allows you to perform a cut of the
AuxKey background on the selected Aux Bus.
•
AuxBkgdTrans
— Select this option to assign an AuxKey Background Transition
to the selected crosspoint button. The AuxBkgdTrans allows you to perform a
transition of the AuxKey background on the selected Aux Bus. Refer to the section
“
AuxKeys Setup ” on page 8-15 for information on setting the AuxKey transition
rate.
Note On a Synergy 1.5 Q/MD , the MLE 2 Clean Feed is not supported.
Only BNCs B05 and B06 provide a dedicated Clean Feed for the
bottom, Program/Preset MLE.
Note On a Synergy 2.5 Q/MD, the MLE 3 Clean Feed is not supported.
Only BNCs B05 and B06 provide a dedicated Clean Feed for the
bottom, Program/Preset MLE.
Important Selecting the Preview with Overlay on the Preset Bus of the bottom
MLE will cause a feedback loop. This feedback loop does not apply if
you have the
Mix/DSK or MultiDSK option installed.