Ross Synergy MD, Инструкция по эксплуатации, Страница: 216 / 388

8–12 • Output Configuration Synergy Q/MD Engineering Manual (v9.1 MD)
MultiDSK Option
The MultiDSK option provides 2 additional Downstream Keyers for your Program/Preset MLE. For
the
Synergy 1 Q/MD this option provides two Downstream Keyers, DSK 1 and DSK 2, and for the
Synergy 1.5 through 2.5 Q/MD this option provides two additional Downstream Keyers, DSK 3 and
DSK 4. Refer to Chapter 7, “ Keying ”, in the Synergy Q/MD/X Operator’s Manual , for more
information on using MultiDSK.
The MultiDSK option assigns and locks certain BNCs on the Output Board to the main switcher
outputs. These assignments are as follows:
• Output #B01 — This output is locked to Program .
• Output #B02 — This output is locked to Program (same as B01 ).
• Output #B03 — This output is locked to Multi Preview (without Overlay).
• Output #B04 — This output is locked to Multi Preview (same as B03 ).
• Output #B05 — This output is locked to Multi Clean 3 , which is taken before
Downstream Key 3.
• Output #B06 — This output is locked to Multi Clean 4 , which is taken before
Downstream Key 4.
• Output #B07 — This output is set, but not locked, to PRV w/ OVL (Preview with
Overlay).
If you have a half-MLE switcher, you may have both Mix and MultiDSK options installed. The BNC
assignments are different in this case. Refer to the section “
Mix/MultiDSK ” on page 8-14 for details.
MultiDSK Setup
Use the following procedure to turn the MultiDSK option on:
1. Navigate to the Output Menu as follows:
• Press HOME
B
MORE
B
Setup
B
Installation
B
Output .
Note
On a Synergy 1 Q/MD , Mix Clean 3 is taken before Downstream
Keyer 1.
Note
On a Synergy 1 Q/MD , Mix Clean 4 is taken before Downstream
Keyer 2.
Operating
Tip
Output # B07 is automatically set to Preview with Overlay when you
set up a MultiDSK. This can be changed later.
Note The MultiDSK option must be purchased and installed before you can
activate it.