Ross Synergy MD, Инструкция по эксплуатации, Страница: 268 / 388

10–22 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the
Button
knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) or an (@) in the
list have already been programmed.
3. Press
Start Recording
to display the Recording Menu .
4. Press
Insert Special
to display the Insert Special Menu 1-2 .
5. Press
Special
to display the Special Menu .
Insert Special — Special Menu
6. Assign the trigger GPI to a GPI output as follows:
• Use the
Selection
knob to select
Trigger GPI
.
• Use the middle
GPI Output
knob to select the GPI output port you want to trigger.
7. Press Insert to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
8. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
9. Press UP ONE to display the Recording Menu .
Custom Controls — Recording Menu
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.
Note The names that appear in the GPI Output list will also be shown when
editing the custom control. The names are programmed on the GPI
Output Setup Menu . Refer to the section “ Standard GPI Setup ” on
page 11-17 for details.