Ross Synergy MD, Инструкция по эксплуатации, Страница: 270 / 388

10–24 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
MLE 2 and MLE 2 is re-entered onto MLE 3 , the Active MLE Trans custom
control will perform a transition on both MLE 1 and MLE 2 .
7. Press
Insert
to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
8. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
9. Press
UP ONE
to display the Recording Menu .
Custom Controls — Recording Menu
10. Press Finish Recording to finish recording to the selected custom control. The custom
control button will stop flashing.
This completes the procedure for creating an automation custom control macro.
Go To Menu
Use Go To Menu to create custom controls that automatically display Squeeze & Tease MD menus.
You must be flying a key when you run the custom control for the Squeeze & Tease MD menu to
display.
Use the following procedure to create a Squeeze & Tease MD Go To Menu custom control macro:
1. Navigate to the Custom Controls Menu 1-2 as follows:
• Press
HOME B Custom Controls
.
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the Button knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) or an (@) in the
list have already been programmed.
3. Press
Start Recording
to display the Recording Menu .
Important If you have more than one re-entry set up for a shot, the Active MLE
Trans custom control will transition all on-air MLEs . If you have an
MLE re-entered onto the BKGD bus of another MLE , the Active
MLE Trans custom control will transition the MLE re-entry with
whatever you have selected on the PST bus of that MLE .
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.