Ross Synergy MD, Инструкция по эксплуатации, Страница: 327 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–25
Tally on GPIs
Use the
Tally on GPIs
function to specify for each tally if it should be forced on by one of the GPI
inputs.
Tally on GPI Setup Menu
The top knob selects a tally number, while the middle knob specifies which GPI input (or NONE )
should force the tally on. Multiple tallies can be forced on by one GPI input. This forcing is
independent of the tallies being used to indicate, for example, which crosspoints are active. It is not
possible to tell from the tally side if it is on because of a crosspoint being used or because of the GPI
forcing.
GPI Information
Use the View GPI I/O menu to display all the information about the GPI inputs and outputs in a
concise format.
View GPI I/O Menu
For each GPI input, the display shows its transition type, area or custom control button and its
polarity, if it has been assigned to trigger one of these operations. The display will show the associated
Aux Bus, if one has been assigned to a GPI in the
Aux Bus Setup procedure, and will show a list of
tallies that it forces if the GPI has been set up accordingly. If the text cannot all show in the display, it
can be scrolled up and down with the middle knob.
This completes our discussion of setting up GPI inputs and outputs. Refer to the section, “ GPI
Control ”, in the chapter, “ Peripheral Control and More ”, of the Synergy Q/MD/X Operator’s
Manual for operational information.