Ross Synergy MD, Инструкция по эксплуатации, Страница: 243 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Basic Communications Setup • 9–17
13. Assign a start message to the communications with the tally interface as follows:
• Use the
Com Port
knob to select the tally interface you are setting the start
message for.
• Use the
Option
knob to select
Start
.
• Use the
Value
knob to select
None
or
Init
as the start message for the tally
interface.
None
is the recommended setting for this option.
Communications — Extra Options (At Black) Menu
14. Assign an At Black action to the tally interface as follows:
• Use the
Com Port
knob to select the tally interface you are setting the At Black
action for.
• Use the Option knob to select At Black .
• Use the
Value
knob to select the At Black action for the tally interface. You can
select between the following:
~
All Off
— Select this option to have the switcher report that nothing is on-air
when the switcher as at black.
~
Active On
— Select this option to have the switcher not report anything
different when the switcher is at black.
This completes the procedures for setup of the Contribution Serial Tally Protocol option. If you
require further information on the various options and their associated values, contact Ross Video
Technical Support at the number listed in the front of this manual.
Note When you have completed setting up a device, or attempt to leave the
Communications Menu , you will be prompted to Confirm or
Cancel your changes to the installation settings of the switcher. If you
want to keep the changes you have made, press Confirm , and the new
setting will be stored.