Ross Synergy MD, Инструкция по эксплуатации, Страница: 269 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–23
10. Press
Finish Recording
to finish recording to the selected custom control. The custom
control button will stop flashing.
This completes the procedure for programming a GPI output trigger.
Automation
Use the Automation function to create custom controls that accept commands from an external
automation system.
Use the following procedure to create an Automation custom control macro:
1. Navigate to the Custom Controls Menu 1-2 as follows:
• Press
HOME B Custom Controls
.
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the
Button
knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) or an (@) in the
list have already been programmed.
3. Press
Start Recording
to display the Recording Menu .
4. Press
Insert Special
to display the Insert Special Menu 1-2 .
5. Press
Special
to display the Special Menu .
Insert Special Menu 1-2
6. Assign an automation function to the selected custom control macro as follows:
• Use the Selection knob to select Automation .
• Use the
Command
knob to select the command you want the macro to perform.
You can select between the following:
~
Keys Off Air
— Select this option when you want all on-air Keys , on all
MLEs , to be dissolved off-air when the custom control is run.
~
Act MLE Trans
— Select this option when you want all MLEs that are
contributing the PGM output, except for the PGM/PST MLE , to be
transitioned according to the settings in the MLE Transition Group . For
example, if MLE 1, of a Synergy 2.5 Q/MD Switcher , is re-entered onto
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.