Gima 35306, Руководство пользователя

Страница: 97 / 693

97
ENGLISH
for the sensor warm-up.
☞
Always position the sensor with the adapter in an upright position to avoid collection of fluids on the windows of the
adapter. Large concentrations of fluids at this point will obstruct gas analysis.
13.4 Measurement Limitations
The following factors may influence the accuracy of measurement:

Leaks or internal venting of sampled gas

Mechanical shock

Cyclic pressure up to 10 kPa (100 cmH2O)

Other sources of interference, if any.
13.5 Troubleshooting the Sidestream CO
2
Sampling System
When the sampling system of the sidestream CO
2
module works incorrectly, check if the sampling line is kinked. If not,
remove it from the watertrap. If the monitor gives a message indicating the airway still works incorrectly, it indicates that
the watertrap must have been blocked, and you should replace with a new one. Otherwise, you can determine that the
sampling line must have been blocked. Replace with a new sampling line.
13.6 Understanding the CO
2
Display
CO
2
panel (optional)
U nit of EtCO
2
Label of Insired CO
2
L abel of CO
2
and EtCO
2
V alue of EtCO
2
Value of Insired CO
2
L abel
of Respiration rate
V alue
of Respiration rate

: the label and unit of EtCO
2

: the label of FiCO
2

mmHg: the unit of EtCO
2
and FiCO
2

rpm: the unit of Respiration rate

39.9 3.3 14: the value of EtCO
2,
FiCO
2
and respiration rate
13.7 Changing CO
2
Settings
When CO
2
Monitoring is selected, the respiration parameter will be provided by CO
2
module. That is, respiration waveform
area shifts to CO
2
waveform area, respiration parameter area shifts to CO
2
parameter area.