Mazda MX-6 1998, Руководство по ремонту

Страница: 500 / 1282

STARTING SYSTEM
1
Selector cable (KL ATX)
2
Terminal B wire
3 Terminal S wire
4 Starter
a
t
Installation Note (FS)
Starter Installation Note (FS)
• Tighten the starter fitting bolts in the order shown.
FS
STARTER INSPECTION
On-vehicle Inspection
1. Verify that the battery is fully charged.
2. Crank the engine and verify that the starter turns
smoothly without any noise.
3. If not as specified, measure the voltage at
terminals S and B when the ignition switch is in
START position.
Specification
Above 8 V
4. If the voltage is within the specification, remove
the starter and inspect the magnetic switch and
the starter.
5. If the voltage is not as specified, inspect the wiring
harness, ignition switch, starter interlock switch
(MTX), and transaxle range switch (ATX).
No Load Test
1. Verify that the battery is fully charged.
2. Connect the starter, battery, voltmeter, and
ammeter as shown.
W 6 U 1 1 9 W 0 2
W 6 U 1 1 9 W A 4
3. Operate the starter and verify that it turns
smoothly.
4. Measure the voltage and current while the starter
is operating.
Specification
Item
E ngine
FS KL
Voltage (V) 11
Current (A) Below 90
5. If not as specified, repair or replace the inner parts
as necessary.
STARTER INTERLOCK SWITCH INSPECTION (MTX)
1. Disconnect the starter interlock switch connector.
2. Inspect for continuity between terminals of the
starter interlock switch by using an ohmmeter.
: Continuity
C o n d itio n
Term inal
B
c
Clutch pedal not depressed
Clutch pedal depressed
O
---------
----- o
W 6 U 1 1 9 W A 6
W 6 U 1 1 9 W 0 3
[
<
C B
W6U119WA5
0 1 -1 9 -2