Mazda MX-6 1998, Руководство по ремонту

Страница: 1186 / 1282

SECURITY AND LOCKS
K e y R e p la c e m e n t o r A d d itio n
W h e n c u s to m e r h a s b ro u g h t tw o o r m o re v a lid keys
Q
Q
V A L ID K E Y S <
KEY 1
NEW KEY (0
0 ^ 3
KEY 2
KEY 3
W 6 U 9 1 4 W A Y
N ote
• If no specific time interval is given, step should be performed
w ith in 3 0 s e c o n d s
of the previous step.
1. Cut new transponder equipped key(s).
2. Using key 1, turn ignition switch to ON then back to LOCK five times. Key should not remain ON or LOCK for
m o re th a n o n e s e c o n d .
(1) Turn key 1 back to ON. Observe illumination of security light in instrument panel.
(2) Turn key 1 to LOCK and remove key 1 from steering lock. Observe security light goes out.
3. Using key 2, start engine. Observe security light illumination (for 1— 2
s e c o n d s )
and engine continues to run.
(1) Turn key 2 to LOCK and remove from steering lock.
4. Repeat step 3 with key 1.
5. Repeat step 3 with key 3.
6. If there are 4— 8 keys (valid and/or new keys), repeat step 3.
7. Wait for
3 0 s e c o n d s
to quit reprogram mode.
W h e n c u s to m e r h a s b ro u g h t o n ly o n e o r no v a lid key (c o d e w o rd is re q u ire d )
Note
• If no specific time interval is given, step should be performed within 30 seconds of the previous step.
1. Cut new transponder equipped key(s).
2. Using key 1, turn ignition switch to ON then back to LOCK five times. Key should not remain ON or LOCK for
more than one second.
(1) Turn key 1 back to ON. Observe flashing of security light (300 ms ON — 300 ms OFF) in instrument
panel.
(2) Turn key 1 to LOCK and wait for 5 minutes until security light decrease in flashing frequency to 1.2
seconds.
(3) Input code word. (Refer to 09-14 CODE WORD INPUT PROCEDURE.)
(4) Observe security light stops flashing and illuminates.
(5) Start engine by key 1. Observe security light illumination (about 1— 2 seconds) and engine continues to
run.
(6) Turn key 1 to LOCK and remove from steering lock.
3. Using key 2, start engine. Observe security light illumination (for 1— 2 seconds) and engine continues to run.
(1) Turn key 2 to LOCK and remove from steering lock.
4.
R e p e a t s t e p
3
w i t h k e y
3.
5. If there are 4— 8 keys (valid and/or new keys), repeat step 3.
6. Wait for
30 seconds to quit reprogram mode.
NEW KEYS
VALID KEY OR
NEW KEY
W 6 U 9 1 4 W A 2
0 9 -1 4 -1 8