Mazda MX-6 1998, Руководство по ремонту

Страница: 865 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
No.1 Engine Mount Bolt Installation Note
Caution
•
Align the transaxle bolt holes and the
engine mount exactly. Any misalignment
can result in boltes and bolt holes
becoming damaged or stripped during
installation.
1. Use the SST (engine support) to make sure the
transaxle bolt holes and No.1 engine mount align.
2. Tighten the bolts to the specified torque.
Joint Shaft Installation Note
1 . Remove the SST from the transaxle case.
W 6 U 5 1 7 W E F
2. Verify that there is no damage to the oil seal.
3. Hand tighten A bolts.
4. Tighten the A, B bolts to the specified torque.
Tightening torque
43— 61 N*m (4.3— 6.3 kgf-m, 32— 45 ft-lbf}
Lower Arm Installation Note
1. Connect the lower arm to the knuckle and tighten
the clinch bolt.
Tightening torque
44— 58 N-m (4.4— 6.0 kgf-m, 32— 43 ft-lbf}
W 6 U 5 1 7 W E H
2. Install the ABS wheel-speed sensor harness
mounting nuts.
Tightening torque
7.9— 10.7 N-m
(80— 110 kgf-cm, 69.5— 95.4 in-lbf}
W6U517WEG
Tie-Rod End Installation Note
1. Install the locknut.
Tightening torque
43— 56 N-m (4.3— 5.8 kgf-m, 32— 41 ft-lbf}
Drive Shaft Installation Note
Refer to 0 3 -1 3 JOINT SHAFT
REMOVAL/INSTALLATION, Clip Installation Note.
2. Secure the locknut by using a new cotter pin.
0 5 -1 7 B -2 5