Mazda MX-6 1998, Руководство по ремонту

Страница: 1204 / 1282

EXTERIOR TRIM
SIDE PROTECTOR No.1, No.2 INSTALLATION
1. Remove the adhesive remaining on the side
protector (if it will be reused) and the body by
using a razor knife.
2. Remove any grease or dirt from the adhesion
surface of the side protector (if it will be reused)
and body.
3. Attach double-sided adhesive tape to the side
protector as shown (if it will be reused.).
SIDE PROTECTOR No.1 DOUBLE-SIDED
ADHESIVE TAPE
SIDE PROTECTOR No.2
W 6 U 9 1 6 W 0 8
4. Peel off the wax paper from the double-sided
adhesive tape and attach the side protector onto
the body as shown.
Nominate
(mm {in})
Clearance (mm {in})
Minimum Maximum
A
2.5 (0.10}
1.5(0.06} 3.5 (0.13)
B
11.0(0.43}
— —
C
50.0(1.97}
— —
D
35.0(1.38}
— —
Distance from vehicle
front end (mm {in})
Nominate (mm {in})
A 1600 (62.99}
208.5(8.21}
B
2000 (78.74} 212.1 (8.35}
C
2500 (98.43} 216.9(8.54}
D 2600(102.36} 218.0(8.58}
E
2900(114.17} 220.7 (8.69}
F
3150(124.02}
223.1 (8.78}
1 .5 — 2 . 5 { 0 .0 6 — 0 .0 9 }
3 .5 — 4 . 5 { 0 .1 4 — 0 .1 7 }
DOUBLE-SIDED
ADHESIVE TAPE
W 6 U 9 1 6 W A 5
WINDSHIELD MOLDING REMOVAL
W 6 U 9 1 6 W 0 9
Note 1. Remove the cowl grille.
• Windshield molding is a replacement part. 2. Pull the windshield molding forward to remove it.
W 6 U 9 1 6 W 1 0
3. Insert the blade of the SST (Sealant remover) into
the sealant, and pull on the bar to cut the sealant
near the body as shown.
W INDSHIELD MOLDING INSTALLATION
1. Apply protective tape along the edge of the body
to protect it from damage.
2. Cut the sealant by using a razor knife as shown.
GLASS | | _ _ J ____ - RAZOR KNIFE
PROTECTIVE TAPE
W 6 U 9 1 6 W A 8
0 9 -1 6 -3