Mazda MX-6 1998, Руководство по ремонту

Страница: 612 / 1282

DRIVE SHAFT
W 6 U 3 1 3 W A Y
2. Install a new snap ring.
W 6 U 3 1 3 W B 2
5. Set the drive shaft by keeping the standard length.
LEFT
Boot Assembly Note
1. Fill the boot with the grease supplied in the boot
kit.
Grease amount
90— 110 g {3.18— 3.88 oz}
W 6 U 3 1 3 W B 0
RIGHT
2. Slide the boot onto the shaft.
Cage, Inner Ring, Balls, Snap Ring, Assembly
Note
1. Align the marks, and install the balls and cage to
the inner ring in the direction shown in the figure.
Caution
•
Install the cage with the offset facing the
snap ring groove. If incorrectly installed,
the drive shaft may become disengaged.
ABS Sensor Rotor Assembly Note
Caution
•
Verify the direction of the sensor rotor.
• Set a new ABS sensor rotor on the drive shaft and
press it on with the
SST.
W 6 U 3 1 3 W A Z
Outer Ring, Clip Assembly Note
Note
• Use the specified grease supplied in the boot
kit and joint kit.
1. Fill the boot (transaxle side) and outer ring with
the specified grease.
Grease amount
120— 140 g {4.3—4.9 oz}
2. Align the marks, and install the outer ring onto the
shaft.
3. Install a new clip.
4. Install the boot.
MARKS
W 6 U 3 1 3 W B 3
Standard length
Right side: 595.2—605.2 mm {23.44— 23.82 in}
Left side: 643.7— 653.7 mm {25.35— 25.73 in}
6. Release trapped air from inside the boot
(transaxle side) by using a screwdriver covered
with a rag.
SNAP RING INNER
GROOVE R|NG
W 6 U 3 1 3 W B 1
0 3 -1 3 -1 0