Mazda MX-6 1998, Руководство по ремонту

Страница: 1151 / 1282

GLASS/WINDOWS/MIRRORS
9. Remove the glass.
Reusing Rear Window Glass
1. Disconnect the negative battery cable.
2. Remove the C-pillar trim. (Refer to 09-17
C-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the rear package trim. (Refer to 09-17
REAR PACKAGE TRIM
REMOVAL/INSTALLATION.)
4. Apply protective tape along the edge of the
headliner to protect it from damage.
5. Apply protective tape along the edge of the body
to protect it from damage.
Note
• The rear window molding is a replacement
part.
6. Remove the lip of the rear window molding by
using a razor knife.
PROTECTIVE TAPE
7. Make a hole through the sealant from the inside of
the vehicle by using an awl.
8. Pass the SST (piano wire) through the hole.
9. Wind each end of the wire around bar.
Note
• Use the entire length of piano wire to prevent
it from breaking when cutting through the
sealant.
10. Working with another person, saw through the
sealant around the edge of the glass, being
careful to not damage the vehicle body.
W 6 U 9 1 2 W A N
11. Remove the rear window glass.
12. Remove the clips and dam.
CENTER
CLIP
o
W 6 U 9 1 2 W A P
13. Remove the clips from the body.
14. Remove the rear window molding from the rear
window glass.
REAR WINDOW GLASS
REAR WINDOW MOLDIN
g
O
W 6 U 9 1 2 W A O
W 6 U 9 1 2 W A M
0 9 -1 2 -1 0