Mazda MX-6 1998, Руководство по ремонту

Страница: 15 / 1282

GENERAL INFORMATION
Vise
• When using a vise, put protective plates in the
jaws of the vise to prevent damage to parts.
W 6 U 000 WAW
Dynamometer
• When test-running a vehicle on a dynamometer:
•
Place a fan, preferably a vehicle-speed
proportional type, in front of the vehicle.
• Connect an exhaust gas ventilation unit.
• Cool the exhaust pipes with a fan.
• Keep the area around the vehicle uncluttered.
• Watch the water temperature gauge.
Note
• When the vehicle is on a chassis roller and
only the front wheels rotate, the ABS warning
light may illuminate. Refer to 04-01
PRECAUTION to turn off the warning light.
INSTALLATION OF RADIO SYSTEM
If a radio system is installed improperly or if a
high-powered type is used, the CIS and other
systems may be affected. When the vehicle is to be
equipped with a radio, observe the following
precautions:
1. Install the antenna at the farthest point from
control modules.
W 6 U 0 0 0 W 0 5
2. Install the antenna feeder as far as possible from
the control module harnesses.
3. Ensure that the antenna and feeder are properly
adjusted.
4. Do not install a high-powered radio system.
ELECTRICAL SYSTEM
Electrical Parts
Battery cable
• Before disconnecting connectors or removing
electrical parts, disconnect the negative battery
cable.
W 6 U 000 W 06
W
6
U
000
WAX
Disconnecting connectors
• When disconnecting two connectors, grasp the
connectors, not the wires.
Connectors
Data link connector
• Insert the probe into the service hole when
connecting a jumper wire to the data link
connector.
Caution
•
Inserting a jumper wire probe into the data
link connector terminal may damage the
terminal.
W 6 U O O O W A Y
W 6 U O O O W A Z
0 0 -0 0 -1 3