Mazda MX-6 1998, Руководство по ремонту

Страница: 955 / 1282

TROUBLESHOOTING [AIR BAG SYSTEM]
STEP INSPECTION
ACTION
Turn ignition switch to LOCK.
Disconnect negative battery cable and wait for
more than 1 minute to allow the backup power
supply of SAS unit to deplete its stored power.
Disconnect clock spring connector.
Remove glove compartment.
Disconnect passenger-side air bag module
connector.
Disconnect SAS unit connector.
Connect negative battery cable.
Turn ignition switch to ON.
Measure voltage at terminal AB or Z at SAS unit
connector of wiring harness.
Is voltage more than 9 V?
A B "^
W 6 U 8 0 1 W A U
Yes
Replace SAS unit.
x t
0 8-10 SAS UNIT REMOVAL/INSTALLATION
No Replace or repair wiring harness between joint box and
SAS unit.
DTC 6 Driver-side air bag module
DETECTION
CONDITION
Resistance detected between terminals M - 0 of SAS unit is other than 2 CX
POSSIBLE
CAUSE
• Driver-side air bag module malfunction
• Clock spring malfunction
• Malfunction in wiring harness between SAS unit and driver-side air bag module
STEP
INSPECTION
ACTION
1 Warning
• Handling the air bag module and SAS unit
improperly can accidently deploy the air
bag modules which may cause serious
Injury. Read AIR BAG SYSTEM SERVICE
WARNINGS before handling the air bag
module and SAS unit.
x t
0 8 -1 0 AIR BAG SYSTEM SERVICE
WARNINGS
Turn ignition switch to LOCK.
Disconnect negative battery cable and wait for
more than 1 minute to allow the backup power
supply of SAS unit to deplete its stored power.
Remove driver-side air bag module.
x t
0 8 -1 0 DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION
Is clock spring pin okay?
Yes Go to next step.
----------------- W 6 U 8 0 1 W A 9
No Replace clock spring.
xr 0 8 -1 0 CLOCK SPRING REMOVAIVINSTALLATION
0 8 -0 1 A -5