Mazda MX-6 1998, Руководство по ремонту, Страница: 797 / 1282

MANUAL TRANSAXLE
05-15 MANUAL TRANSAXLE
TRANSAXLE OIL IN S P E C T IO N .............. 05-15-1
TRANSAXLE OIL REPLACEMENT . . . . 05-15-1
OIL SEAL (DIFFERENTIAL)
R EPLA C EM EN T....................................... 0 5 -1 5 -2
VEHICLE SPEEDOMETER SENSOR
IN S P E C TIO N ............................................. 0 5 -1 5 -2
VEHICLE SPEEDOMETER SENSOR
REM OVAL/INSTALLATION....................0 5 -1 5 -2
MANUALTRANSAXLE
REMOVAL/INSTALLATION.................... 0 5 -1 5 -3
Engine Mount Member Removal Note 0 5 -1 5 -6
Transaxle Removal N o te ........................ 0 5 -1 5 -6
Transaxle Installation Note ................ 0 5 -1 5 -6
No.2 Engine Mount, Engine Mount Member
Installation Note .................................... 0 5 -1 5 -6
TRANSAXLE OIL INSPECTION
W 6 U 5 1 5 W 0 1
4. If the oil level is lower than the low level, add the
specified amount and type of oil through the oil
level plug hole.
Specified oil grade
API Service GL-4 or GL-5
Specified oil viscosity
All-season: SAE 75W -90
Above 10 'C (50 ”F}: SAE 80W -90
5. Install a new washer and the oil level plug.
Tightening torque
40— 58 N m {4.0—6.0 kgf-m, 29— 43 ftlb f}
TRANSAXLE OIL REPLACEMENT
1. Remove the drain plug and washer.
2. Drain the oil into a suitable container.
3. Install a new washer and the drain plug.
Tightening torque
40— 58 N m {4.0—6.0 kgf-m, 29— 43 ft lbf}
4. Remove the oil level plug with washer and add the
specified amount and type of oil through the oil
level plug hole until the level reaches the bottom
of the oil level plug hole.
Specified oil grade
API Service GL-4 or GL-5
Specified oil viscosity
All-season: SAE 75W -90
Above 10 °C {50 °F}: SAE 80W -90
Capacity
2.7 L {2.9 US qt, 2.4 Imp qt}
W 6 U 5 1 5 W 0 2
OIL LEVEL
HIGH
i : LEVEL
3__ LOW
„ _____ LEVEL
ABOUT \ --------
6 mm {0.236 In)
N \ -
W 6 U 5 1 5 W A 1
5. Install a new washer and the oil level plug.
Tightening torque
40— 58 N m {4.0—6.0 kgf-m, 2 9 - ^ 3 ft lbf}
1. Park the vehicle on level ground.
2. Remove the oil level plug and washer.
3. Verify that the oil is near the bottom of the plug
port.
HIGH
LEVEL
LOW
LEVEL
0 5 -1 5 -1