Mazda MX-6 1998, Руководство по ремонту, Страница: 1153 / 1282

GLASS/WINDOWS/MIRRORS
MOLDING
W 6 U 9 1 2 W A W
{
0
.
2
}
5
11— 13
{0.44— 0.51}
13. Press firmly inward on the glass to compress the
sealant.
14. Use a scraper to smooth away any sealant that
oozes out.
Hardening time of sealant
Temperature
Surface
hardening time
Time required
until car can be
put into service
5 °C {41 °F} Approx. 1.5 h
Approx. 12 h
20 °C {68 °F} Approx. 1 h Approx. 4 h
35 °C {95 °F} Approx. 10 min Approx. 2 h
15. Check for water leaks. If the leak is found, wipe
the water off well and repeat the installation.
16. Install the rear package trim. (Refer to 09-17
REAR PACKAGE TRIM
REMOVAL/INSTALLATION.)
17. Install the C -pillartrim . (Refer to 0 9 -1 7 C-PILLAR
TRIM REMOVAL/INSTALLATION.)
18. Connect the negative battery cable.
6.7 {0.26}
W 6 U 9 1 2 W A X
WINDSHIELD REMOVAL
Not Reusing Windshield
1. Remove the rearview mirror. (Refer to 09-12
REARVIEW MIRROR REMOVAL.)
2. Remove the A-pillar trim. (Refer to 09-17
A-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the cowl grille. (Refer to 09-16 COWL
GRILLE REMOVAL/INSTALLATION.)
4. Remove the windshield molding. (Refer to 09-16
WINDSHIELD MOLDING REMOVAL.)
5. Apply protective tape along the edge of the body
to protect it from damage.
6. Remove the sunvisor, and apply protective tape
along the edge of the headliner to protect it from
damage.
7. Apply protective tape to the dashboard to protect
it from damage.
Note
• For the areas of the sealant that are difficult to
cut, use a piano wire and follow the
procedures under “ Reusing Windshield” .
8. Use a tool like that shown in the figure, and insert
the blade into the sealant.
9. Pull through the sealant around the edge of the
glass.
W 6 U 9 1 2 W 1 7
1 / /X -------------------- W 6 U 9 1 2 W A Z
10. Remove the glass.
Reusing Windshield
1. Remove the rearview mirror. (Refer to 09-12
REARVIEW MIRROR REMOVAL.)
2. Remove the A-pillar trim. (Refer to 09-17
A-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the cowl grille. (Refer to 0 9 -1 6 COWL
GRILLE REMOVAL/INSTALLATION.)
4. Remove the windshield molding. (Refer to 09-16
WINDSHIELD MOLDING REMOVAL.)
5. Apply protective tape along the edge of the body
to protect it from damage.
6. Remove the sunvisor, and apply protective tape
along the edge of the headliner to protect it from
damage.
11. Align the clips and install the glass on the body.
12. Verify that the gap along the upper edge is 6.8
mm {0.27 in}, lower edge is 6.7 mm {0.26 in} and
sides edge are 7.1 mm {0.28 in}.
7.1 {0.28}
mm {in}
0 9 -1 2 -1 2