Mazda MX-6 1998, Руководство по ремонту

Страница: 100 / 1282

TROUBLESHOOTING [ENGINE CONTROL FS]
DTC P0453 Evaporative emission control system fuel tank pressure sensor circuit high input
DESCRIPTION • DTC P0453 indicates Fuel Tank Pressure (FTP) signal circuit input above the maximum.
[Possible Cause]
• FTP signal circuit open • FTP sensor ground open
• FTP signal circuit shorted to constant voltage circuit or • Damaged FTP sensor
power circuit • Damaged PCM
• Constant voltage shorted to power circuit
STEP
INSPECTION
ACTION
1 VERIFY FTP SIGNAL CIRCUIT VOLTAGE
• Key on, engine off.
Note
• FTP sensor input with no pressure/vacuum
on fuel tank (fuel filler cap open or not open
to atmosphere) is 2.37— 2.87 volts.
• Access FTP V PID with NGS tester.
•
Is FTP V PID voltage greater than 4.50
volts?
Yes FTP signal circuit voltage is greater than acceptable
maximum.
Go to next step.
No
The fault that produced DTC P0453 is intermittent.
Perform the Wiggle/Tap test.
2 CHECK FTP AT FTP SENSOR FOR SHORT
TO POWER CIRCUIT
• Key off.
• Disconnect FTP sensor vehicle harness
connector.
• Key on, engine off.
• Measure voltage between FTP signal
circuit at FTP sensor vehicle harness
connector and battery ground.
• Is voltage greater than 10.5 volts?
Yes
The FTP is indicating short to power circuit.
Go to next step.
No Go to step 4.
3
CHECK FTP SIGNAL CIRCUIT FOR SHORT
TO POWER CIRCUIT
• Key off.
• FTP sensor disconnected.
• Disconnect PCM. Inspect for damaged or
pushed out pins, corrosion and loose wires.
Service as necessary.
• Install breakout box. Leave PCM
disconnected.
• Key on, engine off.
• Measure voltage between Test Pin 62 and
Test Pins 51 and 103 at breakout box.
• Is voltage greater than 10.5 volts?
Yes SERVICE harness short between FTP and power circuit.
REMOVE breakout box.
RECONNECT all components.
RESET PCM to completely clear DTCs.
tr After Repair Procedure
COMPLETE OBD II Drive Mode.
RERUN OBD Test.
No FTP is shorted to power circuit in PCM.
REPLACE damaged PCM.
REMOVE breakout box.
RECONNECT all components.
RERUN OBD Test.
4 INDUCE OPPOSITE SIGNAL
• Key off.
• FTP sensor disconnected.
• Connect jumper wire between sensor FTP
sensor ground circuit and FTP circuit at
FTP sensor harness connector.
• Key on, engine off.
• If NGS tester communication concern
exists, remove jumper immediately and
check FTP signal short to constant voltage
in PCM or harness.
• Access FTP V PID with NGS tester.
•
Is FTP V PID voltage less than 0.10 volt?
Yes
REMOVE jumper wire.
Go to next step.
No Unable to induce opposite signal.
5 VERIFY THAT CONSTANT VOLTAGE IS IN
RANGE
• FTP sensor disconnected.
• Key on, engine off.
• Measure voltage between constant voltage
circuit and FTP sensor ground circuit at
FTP sensor vehicle harness connector.
• Is constant voltage between 4.0 and 6.0
volts?
Yes Go to next step.
No
Constant voltage is out of range.
0 1 -0 1 A -7 2