Mazda MX-6 1998, Руководство по ремонту

Страница: 929 / 1282

BASIC SYSTEM
{1 .5 — 2 .2 k g f-m , 11— 15 t t l b f }
1 Connector
2 Bolt
3 A/C compressor
tf Installation Note
A/C Compressor Installation Note
• Remove the following amount of SP-20
compressor oil from the new A/C compressor
when replacing the A/C compressor.
Compressor oil to be removed
240 ml {240 cc, 8.11 fl oz} - [compressor oil
from old A/C comp 15 ml {15 cc,
0.5 fl oz}]
W 6 U 7 1 1 W A C
CONDENSER REMOVAL/INSTALLATION
1. Discharge the refrigerant from the system.
2. Disconnect the negative battery cable.
3. Remove the upper seal board.
Caution
•
If moisture or foreign material enters the
refrigeration cycle, cooling ability will be
lowered and abnormal noise will occur.
Always immediately plug all open fittings
after removing any refrigeration cycle
parts to keep moisture or foreign material
out of the cycle.
4. Disconnect cooler pipe No.1 and No.3. (Refer to
07-11 REFRIGERANT LINES
REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table. Do not
allow compressor oil to spill.
6. Install in the reverse order of removal.
7. Recharge with refrigerant. (Refer to 07-10
REFRIGERANT CHARGING.)
8. Perform the refrigerant system performance test.
(Refer to 07 -1 0 REFRIGERANT SYSTEM
PERFORMANCE TEST.)
1 Bolt
2
Condenser bracket
3 Condenser
w
Installation Note
W 6 U 7 1 1 W 1 5
W 6 U 7 1 1 W A D
0 7 -1 1 -9