Mazda MX-6 1998, Руководство по ремонту, Страница: 444 / 1282

LUBRICATION SYSTEM
2. Use a clean rag to wipe off the mounting surface
on the oil filter body.
3. Apply clean engine oil to the O-ring of the oil filter.
4. Tighten the filter according to the installation
direction on the side of it or packing box by using
the SST.
5. Start the engine and inspect for oil leakage.
6. Inspect the oil level and add oil as necessary.
(Refer to 01-11 ENGINE OIL LEVEL
INSPECTION.)
OIL PRESSURE INSPECTION
Warning
• Continuous exposure with USED engine
oil has caused skin cancer in laboratory
mice. Protect your skin by washing with
soap and water immediately after this
work.
• When the engine and the oil are hot, they
can badly burn. Turn off the engine and
wait until they are cool.
1. Remove the intake manifold bracket. (FS)
2. Remove the oil pressure switch.
3. Screw the
SST into the oil pressure switch
installation hole.
FS
W 6 U 1 1 1 W A 2
KL
W 6 U 1 1 1 W 0 4
5. Run the engine at the specified speed, and note
the gauge readings.
Note
• The oil pressure can vary with oil viscosity and
temperature.
Oil pressure
FS: 393— 490 kPa
{4.0— 5.0 kgf/cm2, 57— 71 psi} [3,000 rpm]
KL: 334— 490 kPa
{3.4— 5.0 kgf/cm2, 49— 71 psi} [3,000 rpm]
6. If the pressure is not as specified, inspect for
amount of engine oil, oil leakage, or any wear
parts inside of engine etc. Repair or replace as
necessary.
7. Stop the engine and wait until it is cool.
8. Apply silicone sealant to the oil pressure switch
threads as shown.
9. Remove the SST.
1.0— 2 .0 m m
{0 .0 4 — 0 .0 7 in}
W 6 U 1 1 1 W A 4
4. Warm up the engine to normal operating
temperature.
10. Install the oil pressure switch.
Tightening torque
12— 17 N m {1 .2 — 1.8 kg f-m , 9— 13 ft-lb f}
11. Start the engine and inspect for oil leakage.
12. Install the intake manifold bracket. (FS)
0 1 -1 1 -2