Mazda MX-6 1998, Руководство по ремонту

Страница: 1199 / 1282

SLIDING SUNROOF
SUNROOF MOTOR REMOVAL
1. Fully close the glass panel.
2. Disconnect the negative battery cable.
3. Remove the headliner. (Refer to 09-17
HEADLINER REMOVAL/INSTALLATION.)
4. Disconnect the connector.
5. Remove the screws, and remove the sunroof
motor.
SUNROOF MOTOR INSTALLATION
1. Connect the sunroof motor connector.
2. Connect the sunroof switch connector.
3. Connect the negative battery cable.
4. Turn the IG switch to ON.
5. Press the CLOSE side of the slide switch until the
sunroof motor stops.
W 6 U 9 1 5 W 1 2
6. Disconnect the sunroof switch connector.
7. Install the screws, and install the sunroof motor.
8. Install the headliner. (Refer to 09-17 HEADLINER
REMOVAL/INSTALLATION.)
SUNROOF SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Disengage the clip A by using a tape-wrapped
flathead screwdriver as shown in the figure.
3. Pull the sunroof switch downward to disengage
hook B from the headliner.
W 6 U 9 1 5 W 1 3
4. Disconnect the connector, and remove the
sunroof switch.
SUNROOF SWITCH INSPECTION
1. Remove the sunroof switch. (Refer to 09-15
SUNROOF SWITCH REMOVAL/INSTALLATION.)
2. Check for continuity between the sunroof switch
terminals by using an ohmmeter.
O O : C o n t in u ity
Switch
position
Slide open
Slide close
Tilt-up
Tilt-down
Terminal
O-
O-
0 -
-o
W 6 U 9 1 5 W A L
r T ? m
I SLIDE
T CLOSE
TILT- I
d o w n
Y
TILT-
-<D>
W 6 U 9 1 5 W 1 4
F E D ! * B A
W6U915WAM
3. If not as specified, replace the sunroof switch.
A
W 6 U 9 1 5 W A P
0 9 -1 5 -7