Mazda MX-6 1998, Руководство по ремонту

Страница: 593 / 1282

DRIVELINE/AXLE
03
SECTION
GENERAL PROCEDURES . . . . 03-10
FRONT AXLE ........................... 03-11
REAR AXLE ............................. 03-12
DRIVE S H A F T ........................... 03-13
TECHNICAL D A TA .................... 03-50
SERVICE T O O L S ..................... 03-60
03-10 GENERAL PROCEDURES
PRECAUTION (DRIVELINE/AXLE) . . . . 0 3 - 1 0 - 1 Brake Line Disconnection/Connection 0 3 -1 0 -1
Wheel and Tire Removal/Installation .. 0 3-10-1 Suspension Arm Removal/Installation 0 3 -1 0 -1
PRECAUTION (DRIVELINE/AXLE)
W 6 U 3 1 0 W 0 1
Wheel and Tire Removal/Installation Suspension Arm Removal/Installation
• The removal and installation procedure for the
wheels and tires are not mentioned in this section.
When a wheel is removed, tighten it to
89— 117
N m {9.0— 12.0 kg fm , 66— 86 ft lbf}.
Brake Line Disconnection/Connection
Caution
•
Brake fluid will damage painted surfaces.
If brake fluid does get on a painted
surface, wipe it off immediately.
• Tighten the brake pipe flare nut by using the SST
(49 0259 770B). Be sure to modify the brake pipe
flare nut tightening torque to allow for use of a
torque wrench-SST combination. (Refer to 00-00
FUNDAMENTAL PROCEDURES, TORQUE
FORMULAS.)
• If any brake line has been disconnected any time
during the procedure, add brake fluid, bleed the
brakes, and inspect for leakage after the
procedure has been completed.
• Tighten any part of the suspension that uses
rubber bushings only after vehicle has been
lowered and unloaded.
Note
• Unloaded ... Fuel tank full; engine coolant and
engine oil at specified level; spare tire, jack,
and tools in designated position.
0 3 -1 0 -1