Mazda MX-6 1998, Руководство по ремонту

Страница: 862 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
Selector Cable Removal Note
1. Disconnect the selector cable from the manual
shaft lever.
W 6 U 5 1 7 W D W
2. Pull out the selector cable from the cable bracket
and remove it.
Lower Arm Removal Note
1. Remove the clinch bolt from the lower arm ball
joint.
1. Remove the cotter pin and nut.
2. Disconnect the tie-rod end from the knuckle by
using the SST.
Drive Shaft Removal Note
1. Remove the clip.
2. Remove the ABS wheel-speed sensor harness
mounting nuts.
W 6 U 5 1 7 W D X
2. Wrap a rag around the ball joint dust boot.
3. Pry the lower arm out of the knuckle.
W 6 U 5 1 7 W D Y
Tie-Rod End Removal Note
Caution
•
The sharp edges of the SST can slice the
tie-rod end dust boot. Install the SST so
that the sharp edges are between the dust
boot and the knuckle.
Caution
•
The sharp edges of the drive shaft snap
ring can slice or puncture the oil seal. Be
careful when removing the drive shaft from
the transaxle.
4. Separate the passenger side drive shaft from the
transaxle by prying with a bar inserted between
the outer ring and the transaxle, as shown in the
figure.
O
o o
W 6 U 5 1 7 W E 1
CLIP
W 6 U 5 1 7 W E 0
3. Separate the driver side drive shaft from the joint
shaft by using a brass bar and a hammer.
0 5 -1 7 B -2 2